There is no better way to enjoy a warm dip than a pool heating pump from aquark website. However, the pool heat pumps may run into a variety of problems. Some of these problems are avoidable, while others are unavoidable. Though, you may not have proper ways on how to check for these issues. Here are some troubleshooting points that you may want to check for in your pool heat pumps.
Checking the power flow
Power source issues are among the most common troubleshooting issues that you may come across in your pool heat pumps. You would conclude that your pool heat pump has power flow issues when there are no issues in the electrical connection of the heat pump, yet it is not working.
When inspecting, check and make sure that all the power sources are well connected to the right ports and plugs. Also, keep a close check on the unit’s wiring, making sure that the pump is receiving enough power to operate.
Checking error codes
Sometimes power codes would turn off themselves without you touching anything. The primary cause of this problem is water pressure issues. In such a case, you should first check for the error codes that the control unit displays.
Error codes such as Lo/Hi and Flo signal that the pool heat pump has a shortage in the water supply. This problem may be caused by low pressure or a bad filter. Correcting the filter followed by the pressure would help solve the problem.
Temperature configurations
Pool heater pumps have a common issue when it comes to temperature. These issues are usually caused by the pool owner’s negligence or a fault in the machine. When setting the pool heater temperature, be certain to set the temperature high enough for the heater pump to work effectively.
Sometimes the temperature may be faulty, or the system needs a replacement of the temperature system. The most affected components are the thermostat or knobs. Understanding the type of pool heater system is also key because different types may behave differently.
Suppose you would like to reduce temperature loss in the pool. In that case, a solar cover may be ideal for keeping the gained temperature in the pool. The solar heater also allows the heater to pump with high efficiency, thus improving the pool heat pump’s performance.
Filters checks
Suppose the pool heater is not getting water as needed. In that case, a filter might be the problem. For good performance, pool heater pumps depend on the steady flow of water, which may cause technical issues when interrupted.
Dirty filters are a key problem that leads to blockage. Consequently, the water flow will change significantly, and the pool heat pump will not function normally. It is essential to frequently check the filter and empty it of any debris occasionally. This preventive maintenance will avoid bigger issues with the pool heat pump in the future.
The pump
The pump operates relative to the amount of water that flows through it. If there is a problem with the water flow and pressure, the pump will not work normally. So, always ensure the flow of water is good before going into further troubleshoots.
